8 CHANNEL TACT SWITCH & DIP SWITCH BOARD FOR MICRO-CONTROLLER DEVELOPMENT BOARDS LIKE ARDUINO AND PIC

8 TACT AND DIP SWITCH FOR MICRO-CONTROLLER DEVELOPMENT BOARD (1)

The board  provides up-to 8 key inputs to your project.

Please refer to the schematic diagram for the configuration of this board.

 

  • Optional 10K resistor network (R-Pack) provides a positive potential at the output until a particular key is pressed. This is the standard practice for key input to a Microcontroller pin.
  • Optional Dip switch array provide the same functionality like the tactile switches which could be used as a DIP Switch Configuration setting in your project.

 

Supply to the board is given at connector CN2 as per the polarity marked on the PCB

 

This project is an ideal addition to various Development boards available from us and otherwise.

 

The project includes all components required for the project. Please check the components supplied to you as per the BOM “Bill of Material” listed in this document. The kit PCB is RoHS Compliant. Component legends and In/Out pins are clearly printed on the PCB.

 

8 TACT AND DIP SWITCH FOR MICRO-CONTROLLER DEVELOPMENT BOARD (3)

8 TACT AND DIP SWITCH FOR MICRO-CONTROLLER DEVELOPMENT BOARD SCHEMATIC

 

8 TACT AND DIP SWITCH FOR MICRO-CONTROLLER DEVELOPMENT BOARD (2)

8 TACT AND DIP SWITCH FOR MICRO-CONTROLLER DEVELOPMENT BOARD PCB LAYOUT

8 TACT AND DIP SWITCH FOR MICRO-CONTROLLER DEVELOPMENT BOARD (1)

8 TACT AND DIP SWITCH FOR MICRO-CONTROLLER DEVELOPMENT BOARD BOM

Leave a Reply

Your email address will not be published. Required fields are marked *