Uni-polar Stepper Motor Driver Using Driver Transistors & L297

Unipolar Stepper Motor Driver Using Transistors and L297 (5)

High Current Unipolar Stepper Motor Controller project is based on chopper drive.  Chopper drive allows for use of higher voltage power supply for better performance and higher speed.  It uses SGS Thomson’s L297 IC and TIP142 transistor.

DOC

  • Logic supply : 5 VDC @ 300 mA
  • Motor Supply : 8 to 30 VDC
  • Connection via 10-pin Box Header for easy interface with any microcontroller development boards
  • External or internal voltage reference option via jumper
  • Onboard preset for current adjustment
  • High speed switching diodes for transistor protection
  • Power-On LED indicator for both the supplies
  • Screw terminal connector for easy supplies and motor connection
  • Heat sink included
  • Four mounting holes 3.2 mm each
  • PCB dimensions 110 mm x 53 mm

Unipolar Stepper Motor Driver Using Transistors and L297 (3) Unipolar Stepper Motor Driver Using Transistors and L297 (2) Unipolar Stepper Motor Driver Using Transistors and L297 (1)

Unipolar Stepper Motor Driver Using Transistors and L297 (4) Unipolar Stepper Motor Driver Using Transistors and L297 (1)

Leave a Reply

Your email address will not be published. Required fields are marked *