2 Channel Relay Shield for Arduino UNO Circuit and PCB layout

2 Channel Relay Shield for Arduino UNO Circuit and PCB layout

2 Channel Relay shield for Arduino UNO can be used in several applications like remote control, on/off AC or Dc load and any circuits which required isolated high current and high voltage. Relay 1 connected to Digital pin D2 and Relay 2 can be controlled through D12 of Arduino PIN. Both relay has optocoupler in input for isolation which protect Arduino from any EMI noise and complete isolation between high volt/current at relay outputs.  Relay shield required separate 12V DC. Two LED indicate the Relay operations. J1,J2 provided In case single supply for relay and Arduino required.

  • Input: 12 VDC @ 84 mA
  • D2 and D12 Arduino connected to Relay inputs
  • Solder PCB Jumper J1 and J2 if Shield and Arduino need common supply
  • High TTL Signal Required to Trigger the Relay
  • Output: Two SPDT relay
  • Relay specification: 5 A @ 230 VAC
  • Trigger level : 2 to 12 VDC
  • Header connector for connecting power and trigger voltage
  • LED on each channel indicates relay status
  • Power Battery Terminal (PBT) for easy relay output connection

 

 

 

 

 

Leave a Reply

Your email address will not be published. Required fields are marked *