Reduction Assembly for Camera slider, CNC Router, Automation, 3D Printer Using NEMA23 Stepper Motor and timing Pulley

Reduction Assembly  for Camera slider Using Nema 23 Motor and Timing Pulley

Reduction assembly provides 4 times the torque capacity of NEMA 23 motor by using large size pulley and belt. Its features timing pulley on the main out shaft to drive timing belt for linear motion. The unit has been designed to drive professional camera slider however it can be used in various CNC and motion control applications. The unit consists Sanyo Denki high torque NEMA23 motor, 18 teeth HTD timing pulley at motor side and 72 teeth timing pulley at output shaft which provides 1:4 ratio reduction, output has HTD 5MM 20 teeth pulley for slider belt driver.  This unit can be used with rack pinion, use Pinion at output shaft instead of timing pulley.

Features

Reduction Ratio 1:4
Nema 23 Motor
Timing Belt 3MM HTD 15MM Width

Open Ended Timing Belt at Output 15MM width 5MM HTD

Output Timing Pulley 20 Teeth 15MM HTD M5 Pulley

Leave a Reply

Your email address will not be published. Required fields are marked *