3 Amps power operational amplifier using lm675

Power operational board can drive high current load up to 3Amps, the board helpful to drive Dc Motor, solenoid, Lamp, LED and industrial application. The project built around LM675 power op-amp from texas instruments. All resistors are 1%. Refer datasheet of LM675 for further information.

I Output= VIN X 2.5amps/volt

i.e Iout=1A when VIN=400mV

Trimmer Pot for Max Rout

Download PDF PCB Layout

The LM675 is a monolithic power operational amplifier featuring wide bandwidth and low input offset voltage, making it equally suitable for AC and DC applications.

The LM675 is capable of delivering output currents in excess of 3 amps, operating at supply voltages of up to 48V. The device overload protection consists of both internal current limiting and thermal shutdown. The amplifier is also internally compensated for gains of 10 or greater.

Features

  • 3A Current Capability
  • AVO Typically 90 dB
  • 5 MHz Gain Bandwidth Product
  • 8 V/μs Slew Rate
  • Wide Power Bandwidth 70 kHz
  • 1 mV Typical Offset Voltage
  • Short Circuit Protection
  • Thermal Protection with Parole Circuit (100% Tested)
  • 16V–48V Supply Range ( +/-12 To 24V DC)
  • Wide Common-Mode Range
  • Internal Output Protection Diodes
  • 90 dB Ripple Rejection

 

Original Circuit from Texas Instruments Data Sheet

Leave a Reply

Your email address will not be published. Required fields are marked *