Circuit Ideas I Electronic DIY Projects I Robotics
Circuit Ideas I Electronic DIY Projects I Robotics
Here is a simple test setup of RC brush-less motor using ESC driver and RC signal generator. RC signal generator based on PIC12F675 microcontroller, Hex code and the circuit is available. The term ESC stands for “electronic speed control. Download Hex Code Complete Project Available Here
Read more
This little project will drive the signal from your balanced Audio source and increase both its volume and detail. The project has been designed for professional audio lovers, this project is easy to make and low-cost solution for audio professionals, The LME49600 , LME49720 and BA4560 ICs are used to design the project, the project can drive 16 Ohms or
Read more
I am here with one more electret microphone preamplifier. This circuit uses an op-amp in a trans-impedance amplifier configuration to convert the output current from an electret capsule microphone into an output voltage. The common mode voltage of this circuit is Constant and set to mid-supply eliminating any input–stage cross over distortion, Circuit and description of the project from Texas
Read more
Knight Rider-2 simple project using Arduino Mega and 20 LEd. This example makes use of 20 LEDs connected to the pins 22 – 41 on the board using 40 Ohm resistors and LED driver IC ULN2003. The code example will make the LEDs blink in a sequence, one by one. Hardware Requirement Arduino Mega ULN2003 X 3 IC 470 Ohms
Read more
Arduino Knight Rider LED effects project consist of 20 LEDs and Arduino mega, refer circuit diagram for LED connections to Arduino. This example makes use of 20 LEDs connected to the pins 22 – 41 on the board using 40 Ohm resistors and LED driver IC ULN2003. The code example will make the LEDs blink in a sequence, one by
Read more
The simple digital voltmeter made using Arduino Nano and 16X2 LCD, the project is tested on TWOVOLT Multi-Project LCD Shield; Arduino has a couple of 10 Bit ADC pins, we have used A0 pin as an input. The PR2 Trimmer pot used as input voltage, Remove PR2 to measure the external voltage. 16X2 LCD used to display the measured voltage.
Read more
4 Channel Infrared (IR) Remote is a simple project using the popular HT12A and HT12D encoder/decoder chips from Holtek. The project can be used in latch mode or momentary mode, mode selection possible using J1 Jumper and transmitter end. All output at the receiver end is TTL. Specifications Supply – Transmitter: 2.4 ~ 5 VDC, 5 V @
Read more
Useful audio device for audio professionals, tiny board is a balanced headphone monitor, based on BA4560 op-amp, project works with 12V DC supply, Female XLR connector helps to feed balanced audio input, male XLR connector for parallel balanced signal output, and 3.5MM Stereo EP socket provided to connect headphone, easy supply input using standard DC socket, onboard potentiometer provided to
Read more
Current sources are widely used in industrial, power supply, LED drivers and other equipment. The project has been developed using the AD8276 difference amplifier and the AD8603 op-amp. Current source using the low power AD8276 difference amplifier and the AD8603 op amp are affordable, flexible, and is small in size. Performance characteristics such as initial error, temperature drift, and power
Read more
The simple DC switching possible with this MOSFET board, the board is made in form of Arduino Nano shield, the board can be used to drive inductive load as well as resistive load, possible application for the shield are LED dimmer, DC Motor speed controller, DC load ON/OFF, solenoid driver, and lamp dimmer. D2 provided for back EMF protection which
Read more