4 Channel Relay Driver Shield For Arduino Nano

 

 

Quad Channel Relay Board Arduino Nano Shield is a simple and convenient way to interface 4 relays for switching application in your project.

Features

     Input supply 12 VDC @ 170 mA

     Output four SPDT relay

     Relay specification 5 A @ 230 VAC

     Trigger level 2 ~ 5 VDC from Arduino I/O D2,D3,D4,D5 Digital Lines

     Power Battery Terminal (PBT) for easy relay output and aux power connection

     LED on each channel indicates relay status

Applications: Robotics, Electronics projects, Industrial controls, Microwaves Oven, Fans, DC Motor, AC Lamp, Solenoids Remote Controls etc.

Relay Load (Contact Capacity of Relay)

 

  •     7 A @ 230-250 VAC
  •     10 A @ 120 VAC
  •     10 A @ 24 VDC
  •     CN1 – CN4 Connector : Relay 1 to 4 (S1 to S4) Output (Normally Open/Normally Close)
  •     CN5 Connector : Control Signal Input, Trigger 2 to 5 VDC and Supply Input 12 VDC
  •     D2,D4,D6,D8 : Relay On/Off LED Indication
  •     CN6 , CN7 12V DC Input

 

 

 

 

Leave a Reply

Your email address will not be published. Required fields are marked *