Studio-Grade Fully Balanced Stereo Headphone Amplifier Using LME49600 and BA4560
This little project will drive the signal from your balanced Audio source and increase both its volume and detail. The project has been designed for professional audio lovers, this project is easy to make and low-cost solution for audio professionals, The LME49600 , LME49720 and BA4560 ICs are used to design the project, the project can drive 16 Ohms or 32 Ohms headphones, The project provides high-quality sound and it can be used in professional studios.
Features
- Supply 15V Dual ( +/-12V DC)
- Current 200mA
- Output Load 16/32 Ohms Headphones
- Input Balanced Stereo
- On-Board Power LED
- 5MM EP Stereo Socket Provided for Headphone
- On Board Potentiometer Helps to Adjust the Gain
- Audio Input Using Screw Terminals
- Screw Terminals for Supply Input
BA4560
Low Noise Dual Supply Voltage Operational Amplifier – BA4560F
General-purpose BA4558 / BA4560 / BA15218 / BA14741 / BA15532 / BA4510 family and high-reliability BA4558R / BA4560R / BA4564R / BA4580R / BA4584 / BA4584R / BA8522R / BA2115 family integrate two or four independent Op-Amps on a single chip Especially, this series is suitable for any audio applications due to low noise and low distortion characteristics and are usable for other many applications by wide operating supply voltage range. BA4558R / BA4560R / BA4564R / BA4580R / BA4584R / BA8522R / BA2115 are high-reliability products with extended operating temperature range and high ESD tolerance.
LME49600
The LME49600 is a high performance, low distortion high fidelity 250mA audio buffer. The LME49600 is designed for a wide range of applications. It can be used inside the feedback loop of op amps. The LME49600 offers a pin-selectable bandwidth: a low current, 110MHz bandwidth mode that consumes 7.3mA and a wide 180MHz bandwidth mode that consumes 13.2mA. In both modes the LME49600 has a nominal 2000V/μs slew rate. Bandwidth is easily adjusted by either leaving the BW pin unconnected or connecting a resistor between the BW pin and the VEE pin.The LME49600 is fully protected through internal current limit and thermal shutdown.
LME49720
The LME49720 device is part of the ultra-low distortion, low noise, high slew rate operational amplifier series optimized and fully specified for high performance, high fidelity applications. Combining advanced leading-edge process technology with state-of-the-art circuit design, the LME49720 audio operational amplifiers deliver superior audio signal amplification for outstanding audio performance. The LME49720 combines extremely low voltage noise density (2.7nV/√Hz) with vanishingly low THD+N (0.00003%) to easily satisfy the most demanding audio applications.
