Water Level Monitor Using pressure sensor & 15led’s Arduino bar-graph display

Project name “Water level monitor using pressure sensor”

I have tested this project with Arduino 15 LED’s Bar-Graph monitor and MPXV5010DP sensor, sensor included inbuilt signal conditioning circuit, output is sufficient to drive the ADC of Arduino, I have used A1 analog pin as input. Water level is around 9 Inch. Operating voltage of this circuit 5V DC.

Arduino Pins

LED 1-15>> DO, D1, D2, D3, D4, D5, D7, D8, D9, D10, D11, D12, D13, A0

MPXV5010DP Output >> Analog Pin A1

Leave a Reply

Your email address will not be published. Required fields are marked *