Circuit Ideas I Electronic DIY Projects I Robotics
The simple digital voltmeter made using Arduino Nano and 16X2 LCD, the project is tested on TWOVOLT Multi-Project LCD Shield; Arduino has a couple of 10 Bit ADC pins, we have used A0 pin as an input. The PR2 Trimmer pot used as input voltage, Remove PR2 to measure the external voltage. 16X2 LCD used to display the measured voltage.
Read more
4 Channel Infrared (IR) Remote is a simple project using the popular HT12A and HT12D encoder/decoder chips from Holtek. The project can be used in latch mode or momentary mode, mode selection possible using J1 Jumper and transmitter end. All output at the receiver end is TTL. Specifications Supply – Transmitter: 2.4 ~ 5 VDC, 5 V @
Read more
Useful audio device for audio professionals, tiny board is a balanced headphone monitor, based on BA4560 op-amp, project works with 12V DC supply, Female XLR connector helps to feed balanced audio input, male XLR connector for parallel balanced signal output, and 3.5MM Stereo EP socket provided to connect headphone, easy supply input using standard DC socket, onboard potentiometer provided to
Read more
Current sources are widely used in industrial, power supply, LED drivers and other equipment. The project has been developed using the AD8276 difference amplifier and the AD8603 op-amp. Current source using the low power AD8276 difference amplifier and the AD8603 op amp are affordable, flexible, and is small in size. Performance characteristics such as initial error, temperature drift, and power
Read more
The simple DC switching possible with this MOSFET board, the board is made in form of Arduino Nano shield, the board can be used to drive inductive load as well as resistive load, possible application for the shield are LED dimmer, DC Motor speed controller, DC load ON/OFF, solenoid driver, and lamp dimmer. D2 provided for back EMF protection which
Read more
Reduction Assembly for Camera slider Using Nema 23 Motor and Timing Pulley Reduction assembly provides 4 times the torque capacity of NEMA 23 motor by using large size pulley and belt. Its features timing pulley on the main out shaft to drive timing belt for linear motion. The unit has been designed to drive professional camera slider however it can
Read more
The versatile DC motor speed controller project is based on PIC16F1825 microcontroller, its generate PWM pulse and also display the value on 2 digit 7 segment display, duty cycle adjustable 0 to 99 %, Frequency 1Khz, the speed of motor possible with help of two tactile switches. The board only generate and display the PWM, project required Mosfet on output
Read more
Simple power supply circuit provides variable output voltage 1.2V to 15V DC and load current up to 3 Amps, onboard trimmer pot provided to adjust the output voltage. Output capacitor C3, C4 provided for transient response, the circuit can take DC input as well as AC input, maximum DC input 15V DC and AC input 12V AC. LM1084-adj IC is
Read more
The compact 5 Phase stepper driver project can handle motor up to 3.5amps supply 12-30V DC, driver has facility to set the load current, driver provides half stepping and full stepping, and easy to drive with step and direction pulse, trimmer pot provided to set the current, The SI-7510 is a pre-driver IC for driving 5-phase stepper motors wound in
Read more
Circuit helps turns ON the switch when temperature reaches to the set point, NTC used as temperature sensor. Circuit built using LM393/LM358, Supply Input 12v DC Watch Video Of This Project
Read more